Concrete Repair & Replacement
Damaged concrete does not fix itself, and small problems become expensive repairs if you wait too long to address them.
When to Repair and When to Replace Concrete
Not all concrete problems require complete replacement. At Grover Beach Concrete, we give you honest advice about whether repair or replacement makes sense for your situation. Small cracks, minor surface damage, and isolated problem areas often respond well to targeted repairs that cost far less than replacement.
Repair works best when the underlying structure remains sound. A few hairline cracks or small chips are normal and do not affect performance. We can seal cracks to prevent water infiltration and patch damaged areas to restore appearance. These repairs extend the life of your concrete at a fraction of replacement cost.
Signs Your Concrete Needs Attention
- Cracks wider than a quarter inch that continue to spread
- Settling or sinking that creates uneven surfaces or trip hazards
- Large sections of spalling where the surface is flaking or crumbling
- Water pooling due to improper slope or settling
- Deep pitting or scaling that exposes aggregate
- Multiple interconnected cracks forming a pattern
- Heaving caused by tree roots or frost
Replacement becomes necessary when damage is extensive or structural. If more than 30 percent of your concrete has problems, replacement often makes more financial sense. Severe settling, major cracking throughout, or structural failure require new concrete. We evaluate your situation and recommend the most cost-effective solution.
Concrete Repair Services We Offer
We offer several repair methods depending on the type and extent of damage. Each technique addresses specific problems and restores function and appearance to your concrete surfaces.
Crack Repair and Sealing
Small cracks get cleaned and filled with flexible sealants that prevent water infiltration. This stops further damage from freeze-thaw cycles and keeps moisture away from the base material. Larger cracks may need routing to create a proper channel for sealant. We use products designed for concrete that remain flexible as temperatures change.
Surface Patching and Resurfacing
Spalling and surface damage can be patched with repair mortar or thin overlays. We remove loose material, prepare the surface, and apply new material that bonds to the existing concrete. For extensive surface problems, a complete overlay provides a fresh surface over sound underlying concrete. This works well for driveways and patios with cosmetic damage.
Leveling and Mudjacking
Settled concrete can often be lifted back to proper grade without replacement. We pump material under the slab to fill voids and raise the surface. This process, called mudjacking or slabjacking, works for sidewalks, driveways, and patios that have sunk but remain structurally sound. It costs significantly less than replacement and takes just a few hours.
Partial Replacement
Sometimes only part of your concrete needs replacement. We can remove and replace damaged sections while leaving good concrete in place. This approach works for isolated problem areas and costs less than complete replacement. We match the existing concrete as closely as possible and ensure proper joints between old and new sections.
Complete Concrete Replacement Process
When replacement is the best option, we handle every step from removal to final finishing. The process starts with removing old concrete. We break up and haul away damaged material, leaving a clean base for new installation.
Site inspection helps us identify why the original concrete failed. Poor drainage, inadequate base preparation, or improper thickness often cause problems. We address these issues during replacement so your new concrete performs better than the original.
- Remove and dispose of damaged concrete
- Evaluate and correct underlying causes of failure
- Prepare base with proper compaction and drainage
- Install reinforcement to prevent future cracking
- Pour and finish new concrete to match or improve original
- Apply proper curing methods for maximum strength
- Clean up job site completely
New concrete follows the same quality standards we use for all our work. Proper base preparation, correct thickness, appropriate reinforcement, and quality finishing ensure your replacement lasts 30 years or more. We apply lessons learned from the original failure to deliver better results. Whether you need foundation work or surface replacement, we build it right the first time.
Repair and Replacement Questions
Fix Your Concrete Problems Today
Contact Grover Beach Concrete for a free inspection and quote. We will evaluate your concrete, explain your options, and recommend the most cost-effective solution. Call (805) 269-8516 or submit our online form.
Call (805) 269-8516